[1]杨玉明.基于轮轨非Hertz接触的货运铁路钢轨磨耗研究[J].高速铁路技术,2024,15(03):34-38.[doi:10.12098/j.issn.1674-8247.2024.03.007]
　YANG Yuming.Study on Rail Wear of Freight Railways Based on Non-Hertzian Wheel-rail Contact[J].HIGH SPEED RAILWAY TECHNOLOGY,2024,15(03):34-38.[doi:10.12098/j.issn.1674-8247.2024.03.007]
点击复制

基于轮轨非Hertz接触的货运铁路钢轨磨耗研究()
分享到：

《高速铁路技术》[ISSN:1674-8247/CN:51-1730/U]

卷:
15卷
期数:
2024年03期
页码:
34-38
栏目:
理论探索
出版日期:
2024-06-20

文章信息/Info

Title:
Study on Rail Wear of Freight Railways Based on Non-Hertzian Wheel-rail Contact
文章编号:
1674-8247（2024）03-0034-05
作者:
杨玉明
新长铁路有限责任公司， 南京210018
Author(s):
YANG Yuming
Xinyi-Changxing Railway Co. ，Ltd. ，Nanjing 210018 ，China
关键词:
钢轨磨耗; 三维铁路钢轨磨耗模型; 外轨磨耗; 内轨磨耗
Keywords:
rail wear; three-dimensional model of rail wear; outer rail wear; inner rail wear
分类号:
U213.4+2
DOI:
10.12098/j.issn.1674-8247.2024.03.007
文献标志码:
A
摘要:
随着铁路运营的发展，货车车辆轴重不断增加，钢轨磨耗异常严重。本文采用UM动力学软件，建立了三维铁路钢轨磨耗模型，计算了红柠铁路专用线部分线路条件下的钢轨磨耗情况。结果表明：（1）线路直线段内外钢轨的磨耗程度相近且较轻；（2）缓和曲线段内轨的磨耗集中分布在距离轮轨作用边轨头约10mm的走行面处，而外轨磨耗集中分布在外轨内侧半径为80mm的弧段曲线上；（3）圆曲线段外轨磨耗严重，主要分布在轨头内侧半径为80mm的弧段上，半径为300mm的弧段上也有明显磨耗；（4）内轨磨耗主要分布在轨头半径为300mm的弧段上，半径为80mm的弧段上磨耗较轻。
Abstract:
With the development of railway operations，the increasing axle loads of freight vehicles have led to severe rail wear. This study employed the UM dynamics software to establish a three-dimensional model of rail wear for freight railways. Calculations were conducted for rail wear under specific track conditions along a private siding of Hongliulin-Shemmuxi Railway. The results reveal that：（1）Wear on the inner and outer rails along straight sections is comparably minor，with little difference observed between them. （2）In transition curves，wear on the inner rail is predominantly concentrated within a distance of approximately 10 mm from the running surface near the rail edge under wheel-rail interaction，whereas outer rail wear is mainly distributed along 80 mm radius arc section on the inner side of the rail. （3）For outer rails in circular curves，wear is severe，primarily occurring on the inner-side arc sections with a radius of 80 mm，with noticeable wear also present on arc sections of 300 mm radius. （4）Inner rail wear is primarily focused on arc sections with 300 mm radius at the rail head，while wear on 80 mm radius arc sections is relatively light.

参考文献/References:

［1］ 马敬武，段晓峰. 货运铁路专用线直线段钢轨磨耗仿真分析［J］.山西建筑，2019，45（17）：114-116. MA Jingwu，DUAN Xiaofeng. Simulation Analysis of Rail Wear of Straight Section in Freight Dedicated Railway［J］. Shanxi Architecture，2019，45（17）：114-116.
［2］ 张逸飞，王保成. 基于动力学分析的更高速度轮轨高速铁路线路平面参数研究［J］. 高速铁路技术，2023. 14（6）：39-45. ZHANG Yifei，WANG Baocheng. Study on the Planar Parameters of Higher-speed Wheel-rail High-speed Railway Based on Dynamic Analysis［J］. High Speed Railway Technology，2023，14（6）：39-45.
［3］ 陈浩. 基于动力分析的高速铁路钢轨磨耗预测方法研究［J］. 高速铁路技术，2022，13（6）：17-22. CHEN Hao. Study on Prediction Method of Rail Wear of High-speed Railway Based on Dynamic Analysis ［J］. High Speed Railway Technology，2022，13（6）：17-22.
［4］ OLOFSSON U，ANDERSSON S，BJ?RKLUND S. Simulation of Mild Wear in Boundary Lubricated Spherical Roller Thrust Bearings［J］. Wear，2000，241（2）：180-185.
［5］ LEWIS R，OLOFSSON U. Mapping Rail Wear Regimes and Transitions［J］. Wear，2004，257（7/8）：721-729.
［6］ WANG Pu，GAO Liang. Numerical Simulation of Wheel Wear Evolution for Heavy Haul Railway［J］. Journal of Central South University，2015，22（1）：196-207.
［7］ 杨新文，姚一鸣，周顺华，等. 基于修正的轮轨非Hertz接触的重载铁路曲线超高对钢轨磨耗的影响分析［J］. 机械工程学报， 2018，54（4）：22-29. YANG Xinwen，YAO Yiming，ZHOU Shunhua，et al. Influence of Curve Superelevation of Heavy Haul Railway on Rail Wear Based on Revised Wheel/Rail Non-Hertz Contact［J］. Journal of Mechanical Engineering，2018，54（4）：22-29.
［8］ 侯茂锐，王卫东，常崇义，等. 动车所小半径曲线钢轨磨耗及减磨措施研究［J］. 铁道学报，2018，40（3）：45-50. HOU Maorui，WANG Weidong，CHANG Chongyi，et al. A Study of Rail Wear on Sharp Curves in EMU Maintenance Depot［J］. Journal of the China Railway Society，2018，40（3）：45-50.
［9］ KALKER J J. Three-dimensional Elastic Bodies in Rolling Contact ［M］. Dordrecht：Kluwer Academic Publishers，1990.
［10］ARCHARD J F. Contact and Rubbing of Flat Surfaces［J］. Journal of Applied Physics，1953，24（8）：981-988.
［11］LI Xia，JIN Xuesong，WEN Zefeng，et al. A New Integrated Model to Predict Wheel Profile Evolution Due to Wear［J］. Wear，2011， 271（1/2）：227-237.

备注/Memo

备注/Memo:
收稿日期：2023-10-26
作者简介：杨玉明（1969-），男，高级工程师。
更新日期/Last Update: 2024-06-30